Raisedoverlaypaneldesign - GE ZIS360NXD Installation Instructions Manual

Design Guide
DISPENSER MODELS:
RAISED OVERLAY PANEL DESIGN
When a raised panel design is to be used,
a custom wide middle rail is required to accept
the dispenser trim.
. The middle rail must be wide enough to allow
for the dispenser trim to overlap the opening.
. The middle rail must be 1.100" total thickness
to accept the dispenser trim.
16-3/4"
10-5/8:1 _1
1!4" Backer Panned
.10" Spacer
3/4"
Overlay Pan_
Wide
Middle
Rail is
Required
DISPENSER TRIM FIT EXAMPLES:
(NOT TO SCALE)
114" FRAMED PANEL
, The dispenser trim fits over the custom
panel and snaps into the freezer door.
, The clips will not engage the door
if the panel is more than 0.250" thick.
, If the panel is less than 0.250" thick,
a noticeable gap may be created
around the dispenser trim.
314" OVERLAY PANEL
, The dispenser trim fits over the custom
panel and snaps into the freezer door.
, The clips will not engage the door
if the panel is more than !.100" thick.
, If the panel is less than !.100" thick,
a noticeable gap may be created
around the dispenser trim.
1/4" FREEZER DOOR
0.250"
Framed Thick
114" Backer Panel
.I 0" Spacer
114" Dispenser Trim
FREEZER DOOR
1.100"
Total Thickness
3/4" Overlay Dispenser Trim