Electrical Interconnection - Hifonics Zeus ZRX1501 Owner's Manual

BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wire kits. Ensure a sufficient profile section
(at least 25 mm ), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove rust-
2
streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after
the installation, because loose connections cause malfunctions, insufficient power supply or interferences.
GND
1
Connect the GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable
and safe electric connection to the negative "–"pole of the battery. Check this ground wire from the battery to the ground point if
possible and enforce it if required. Use a ground wire with a sufficient cross section (at least 25 mm
plus (+12V) power supply wire.
REM
2
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your head unit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
headunit.
BATT+12V
3
Connect the BATT+12V-terminal with the +12V pole of the vehicle's battery. Use a suitable cable with a sufficient cross section
(at least 25 mm ) and install an additional in-line fuse. For safety reasons the distance between the fuseblock and the battery
2
should be shorter than 30 cm. Do not set in the fuse into the fuseblock until the installation is accomplished.
PROTECT BRIDGE
4
If you would like to operate two similar amplifiers in the MASTER/SLAVE mode, connect both amplifiers with the appropriate
enclosed cable on the PROTECT BRIDGE port of each amplifier. This connection ensures in case of a malfunction or a defect
on one of the amplifiers (Master or Slave), that both amplifiers will run into the protection mode and shut down.
FUSE
5
The inserted fuses protect the amplifier from shorts and capacity overload.
LOGO
6
This push button switches the logo illumination on the upper side from blue to white.
FREQ.
POWER PHASE RANGE Q-CONTROL
INSTALLATION INSTRUCTIONS
0° 180° 20Hz 80Hz WIDE NRW
PROTECT
EXTENDED BASS CONTROL
BASS LEVEL
CONTROLLER
ZRX1501

ELECTRICAL INTERCONNECTION

ELECTRICAL INTERCONNECTION
GND REM +12V
PROTECT
BRIDGE
POWER INPUT
1 2 3 4
SUB
BOOST SUB SONIC LP LEVEL
MODE
0dB 18dB SLAVE FULL LP 15Hz 55Hz 35Hz 250Hz MIN MAX
INPUT
AUTO TURN ON
LEVEL
(ONLY IN HI LEVEL INPUT MODE)
LOW OFF
HI ON
SPEAKER
FUSE
ZRX1501
5
L L
R R
LINE IN SLAVE OUT
LOG0
BLUE / WHITE
OUTPUT
6
) and the same size like the
2
). Hereby the amplifier turns on or off with your
2
19