ENGLISH
SPECIFICATIONS
Model
Blade diameter
Hole diameter
Max. Miter angle
Max. Bevel angle
Max. Cutting capacities (H x W)
Miter angle
0°
45° (left and right)
52° (right)
(Note)
* mark indicates that a wood facing with the following thickness is used.
45° (left and right)
-1
No load speed (min
)
Laser Type (LS1214L only)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
・
Read instruction manual.
・
DOUBLE INSULATION
・
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
・
When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
45° (left)
*71 mm x 260 mm
66 mm x 305 mm
(left) *71 mm x 155 mm
66 mm x 170 mm
(right) *71 mm x 175 mm
66 mm x 215 mm
-
Miter angle
0°
52° (right)
European countries: 30 mm, other than European countries: 25.4 mm
Bevel angle
*120 mm x 270 mm
115 mm x 308 mm
*120 mm x 185 mm
115 mm x 218 mm
*120 mm x 160 mm
115 mm x 185 mm
LS1214 24.4 kg, LS1214F 24.6 kg, LS1214L 25.3 kg
END216-4
2
LS1214 / LS1214F / LS1214L
0°
*50 mm x 260 mm
*50 mm x 175 mm
Thickness of wood
20 mm
15 mm
15 mm
Red Laser 650 nm,
LS1214/LS1214F 723 mm x 520 mm x 696 mm
LS1214L 723 mm x 520 mm x 718 mm
fence.
・
Do not place hand or fingers close to
the blade.
・
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
・
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
・
Always remove SUB-FENCE R when
performing right bevel cuts. Failure to
do so may cause serious injury to
operator.
・
Never look into the laser beam. Direct
laser beam may injure your eyes.
305 mm
Left 47° , Right 52°
Left and Right 45°
45° (right)
45 mm x 305 mm
45 mm x 215 mm
-
3,200
1mW ( Laser Class 2 )
/II