Securing Workpiece - Makita LS1214 Instruction Manual

nozzle on the tool.
NOTE:
If you connect a Makita vacuum cleaner to this tool,
•
more efficient and cleaner operations can be
performed.
CAUTION:
Empty the dust box before collected sawdust level
•
reaches the cylinder part.
2
3
006792
2
006794

Securing workpiece

WARNING:
It is extremely important to always secure the
•
workpiece properly and tightly with the vise. Failure
to do so can cause the tool to be damaged and/or
the workpiece to be destroyed. PERSONAL
INJURY MAY ALSO RESULT. Also, after a cutting
operation, DO NOT raise the blade until the blade
has come to a complete stop.
CAUTION:
When cutting long workpieces, use supports that
•
are as high as the top surface level of the turn base.
Do not rely solely on the vertical vise and/or
horizontal vise to secure the workpiece.
Thin material tends to sag. Support workpiece over
its entire length to avoid blade pinch and possible
KICKBACK.
1. Cylinder part
1
2. Dust box
3. Sawdust
1. Cylinder part
1
2. Dust box
1
001549
Sub-fence
1
005593
This tool is equipped with the sub-fence which should
ordinarily be positioned as shown in the figure.
However, when performing left bevel cuts, set it to the
left position as shown in the figure.
CAUTION:
When performing left bevel cuts, flip the fence over
•
to the left position as shown in the figure.
Otherwise, it will contact the blade or a part of the
tool, causing possible serious injury to the
operator.
1
005594
Sub-fence R
2
005595
11
1. Support
2
2. Turn base
1. Sub-fence
1. Sub-fence
1. Sub-fence R
1
2. Screws
2