GE JM250DF1WW Owner's Manual page 25

"LOCK DOOR" flashes
in the display
GEAppliances.com
Possible Causes What To Do
The self-clean cycle has been . Close the oven door.
selected but the door is not
closed.
LOCKED DOOR light
is on when you want
to cook
The oven door islocked
because thetemperature
inside theoven has not
dropped below the
locking temperature.
, Press the CLEAR/OFF pad. Allow the oven to cool.
"F-- and a number You have a function , Pressthe CLEAR/OFFpad. Allow the oven to cool for one
or letter" flash in error code. hour. Put the oven back into operation.
the display
If the function code repeats. . Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank A fuse in your home may be , Replacethe fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the . See the Special features ofyour oven control section.
black-out mode.
Display flashes Power failure. . Reset the clock.
Unable to get the Oven control pads were , The BAKE and BROIL HI/LO pads must be pressed
display to show SF" not pressed properly, at the same time and held for :3seconds.
Power outage, Power outage or surge. . Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the CLEAR/OFFpad, setting the clock
and resetting any cooking function.
"Burning" or"oily" This is normal in a new oven . To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation . This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise A cooling fan may , This is normal. The cooling fan will turn off and on.
25