GE JM250DF1WW Owner's Manual page 14

Using the clock and timer.
i!i !ii iii! ii i/
Make sure the clock is set to the
correct time of day.
To Set the Clock
The clock must be set to the correct time of day
for the automatic oven timing functions to work
properly. The time of day cannot be changed
during a timed baking or self-cleaning cycle.
[Z] Press the CLOCK pad.
[] Press the INCREASEor DECREASEpads.
[] Press the START pad.
[ KITCHEN]
TI M ER I
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
To Set the Timer
[] Pressthe KITCHENTIMERON/OFF pad.
Pressthe INCREASE or DECREASE pads
until the amount of time you want shows
in the display.
If you make u mistake press the KITCHEN
TIMER ON/OFF pad and begin again.
[-_ Press the START pad.
[] When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the KITCHENTIMER
ON/OFF pad is pressed.
The 6-second tone can be canceled by
following the steps in the Specialfeatures of
your oven control section under Tonesat the
End of a Timed Cycle.
To Reset the Timer
If the display is still showing the time remaining,
you may change it by pressing the KITCHEN
TIMERON/OFF pad, then press the INCREASE
or DECREASEpads until the time you want
appears in the display.
If the remaining time is not in the display
(clock,delay start or cooking time are in the
display),recall the remaining time by pressing
the KITCHENTIMERON/OFF pad and then
pressing the INCREASE or DECREASEpads to
enter the new time you want.
To Cancel the Timer
Pressthe KITCHENTIMERON/OFF Dudtwice.
Power Outuge
After u power outage, when power _srestored
the display will flash and time shown will
no longer be correct-for example, after a
5-minute power interruption the clock will be 5
minutes slow.
The display flashes until the clock is reset. All
other functions that were in operation when the
power went out will have to be programmed
again.
14