Advertisement
Available languages
Available languages
Installation
Instructions
CHECK FOR LEAKS
LEAK TESTING OF THE APPLIANCE SHALL BE
CONDUCTED ACCORDING TO THE MANUFACTURER'S
INSTRUCTIONS.
Before testing for leaks, make sure all burner knobs
are in the OFF position.
After connecting
the cooktop to gas, check system
for leaks with a manometer.
If a manometer
is not
available, turn the gas supply on to the cooktop
and use a liquid leak detector
at all joints and
connections
to check for leaks.
Tighten all connections
if necessary to prevent gas
leakage in the cooktop
or supply line.
DO NOT USE OPEN FLAME TO CHECK FOR
LEAKS!
Disconnect the cooktop
and its individual
shut-off
valve from the gas supply piping system during any
pressure testing of that system at test pressures
greater than 1/2 psig (3.5 kPa).
Isolate the cooktop
from the gas supply piping
system by closing its individual
shut-off valve
during any pressure testing of the gas supply
system at test pressures equal to or less than 1/2
psig (3.5 kPa).
[_]
INSTALLATION
OVER
BUILT-IN
OVEN
See built-in oven installation
for complete
installation
instructions.
90 ° Elbow
1
5" To Center of
2" Dia. Hole From
Countertop
2" Dia. Hole
(20 7/8" from front
of Countertop to
Hole Center)
Cabinet Sides __ .J_"
View from Front of Cooktop
Advertisement
