Advertisement
Available languages
Available languages
Installation
Instructions
MAKING THE LP CONVERSION (CONT.}
[_
CHANGE COOKTOP BURNER
ORIFICES
FA1 Remove the grates, burner caps, and burner
heads.
[]
Using a 7mm nut driver, remove the burner
orifices. These may be accessed through
the
burner holes in the cooktop.
Inner
j_,(_
burner cap
Burner
,S_
Outer
base -"-__'
_
burner
cap
Electrode
Burner
Orifice spuds located
_l/
through these openings
Tri-Ring Burner
OR
BurNer
base
Burner
cap
Burner
head
Orifice spud located
Electrode
through this opening
Retainer
Ring
NOTE: On all burners, the
orifices have a spring-loaded
retaining
ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
Fcl
Locate the LP orifices attached to the regulator
along with separate LP conversion instructions.
They will have a digit for size and a letter for type
of gas, on the top or side. (Important:
Save the
orifices removed from the appliance
for future
use.)
Each orifice will show a series of engraved
marks, (I, II, III, IV or V), located on the top.
These marks denote the location of each orifice to the
cooktop
burner.
For PGP976 Models
(Shorter)
For PGP986 & CGP650 Models
r_
CHANGE COOKTOP BURNER
ORIFICES (CONT.)
PGP976
CGP650 &
Main:58 L(x])
PGP986
Simmer: 5! L
CENTER BURNER
17,000 BTU/hr Extra Large Burner (PGP976 Models)
Extended spud for center
extra large burner
Burner
Cap
Set Screw
I
ql_ Choke
I
I
Burner
Head
Extended
Spud
Base
Orifice spud located
through this opening
13
Advertisement
