Aqua Lung GORSKI G2000SS Technical Maintenance Manual page 51

3. Install connector cable lug rings onto the com-
munication posts (22) per the communication posts
pin configuration (Fig. 9) and wiring diagram (Fig.
11). Install the speakers left / right lug rings onto the
communication posts per wiring diagram. Securely
tighten communication post hex nuts to communi-
cation posts with a 3/8" nut driver.
CAUTION: DO NOT overtighten the communication post hex nuts to the communication posts.
Installing Twist-On Connectors
1. Wire the microphone (35) to the connector cable as-
sembly (98 or 100) per the wiring diagram (Fig. 11).
Place stripped wires together with the ends of insulation
even. Twist connector (99) (Fig. 10) onto wires pushing
firmly until hand-tight. Wipe sealant in and around con-
ductors and connector open while tightening.
NoTe: Pre-twisting connector cable wires is not necessary.
NoTe: Twist-on connectors are internally treated with water proof sealant.
2. Hi-Use pin configuration (Fig. 12) and Marsh Marine pin configuration (Fig. 13).
Figure 12
Figure 11
Figure 9
Figure 10
Mic
Speaker
(right)
Speaker
(left)
Figure 13
51