Water Filter Cartridge - GE GSE25ESHBSS Owner's Manual And Installation Instructions

About the automatic icemaker.
A newly-installed refrigerator may take 12-24 hours to begin making ice.
Automatic Icemaker (on
some models)
Power Switch
When the refrigerator has been connected to
the water supply, slide the power switch to the
ON position,
The icemaker will fill with water when it cools
to 15°F, When the bin fills to the level of the
feeler arm, the icemaker will stop producing
ice,
Be sure nothing interferes with the sweep of
the feeler arm,
About th er filter cartrid e. som
Throw away the first few batches of ice to
allow the water line to clear,
The icemaker will produce seven cubes
per cycle-approximately !00-!30
cubes in a 24-hour period, depending on
freezer compartment temperature, room
temperature, number of door openings and
other use conditions,
You will hear a buzzing sound each time the
icemaker fills with water,
Water filter cartridge
The water filter cartridge is located in the back upper right corner of
the refrigerator compartment.
Installing the filter cartridge
H Fill the replacement cartridge with water from the tap
to allow for better flow from the dispenser immediately
after installation.
When to replace the filter on models []
with a replacement indicator light
There is a replacement indicator light for the water filter cartridge
on the dispenser. This light will turn orange to
tell you that you need to replace the filter soon.
The filter cartridge should be replaced wlqen the replacement
indicator light turns red or if the flow of water to the dispenser or
icemaker decreases.
When to replace the filter on models
without a replacement indicator light
The filter cartridge should be replaced every six months
or earlier if the flow of water to the dispenser or
icemaker decreases.
[]
m
Line up the arrow on the cartridge and the cartridge holder. Place
the top of the new cartridge up inside the holder.
Donotpush it up into the holder.
Slowly turn it to the right until the filter
cartridge stops. DO NOT OVERTIGHTEN.
As you turn the cartridge, it will
automatically raise itself into position.
The cartridge will move about a Y_turn.
Run water from the dispenser for 1-1/2 gallons (about three
minutes) to clear the system and prevent sputtering.
Press and hold the RESETWATER FILTERpad (on some models) on
the dispenser for three seconds.
NOTE: A newly installed water filter cartridge may cause water
to spurt from the dispenser.
Removing the filter cartridge
If you are replacing the cartridge, first remove the old one
by slowly turning it to the left. Do not pull down on the cartridge. A
small amount of water may drip down.
CAUTION: To reduce the risk associated with property damage due
to water leakage, read and follow instructions before installation
and use of this system. Installation and use MUST comply with all
state and local plumbing codes.
Filter bypass plug
You must use the filter bypass plug when a replacement filter
cartridge is not available. The dispenser and the icemaker will not
operate without the filter or filter bypass plug.
Filter Bypass 211'[ jl Filter Bypass
Plug J_m_ Plug
SmartWater
, Water by C °,,gao I1 1
To use the filter bypass plug on Water by Culligan" models,
you must first remove the filter adaptor from the cartridge holder by
turning it to the left.
To reduce the risk associated with choking, do not allow children under 3 years of age to have access to small parts
during the installation of this product. The disposable filter cartridge should be replaced every
6 months at the rated capacity, or sooner if a noticeable reduction in flow rate occurs,
For the maximum benefit of your filtration system, GE recommends the use of GE-branded filters only. Using
GE-branded filters in GE and Hotpoint refrigerators provides optimal performance and reliability, GE filters
meet rigorous industry NSF standards for safety and quality that are important for products that are filtering your water, GE has not
qualified non-GE-branded filters for use in GE and Hotpoint refrigerators and there is no assurance
that non-(]E-branded filters meet GE's standards for quality, performance and reliability,
If you have questions, or to order additional filter cartridges, visit our website at www, gewaterfilters,com
or call GE Parts and Accessories, 800,626.2002.
Customers in Canada should consult the yellow pages for the nearest Camco Service Center.