GE GSE25ESHBSS Owner's Manual And Installation Instructions page 12

Installation Instructions
rTl SHUT OFF MAIN WATER SUPPLY
D DRILL THE HOLE FOR THE VALVE
Choose a location for the valve that is easily
accessible, It is best to connect into the side of a
vertical water pipe, When it is necessary to connect
into a horizontal water pipe, make the connection to
the top or side, rather than at the bottom, to avoid
drawing off any sediment from the water pipe,
Drill (_ 1/4" hole in the water pipe (even if using (_ self-
piercing valve) using a sharp bit, Remove any burrs
resulting from drilling the hole in the pipe, Take care
not to allow water to drain into the drill. Failure to
drill a 1/4" hole may result in reduced ice production
or smaller cubes,
?
131FASTEN THE SHUTOFF VALVE
Fasten the shutoff valve to the cold water pipe with
the pipe clamp,
Tighten the clamp screws until the sealing washer
begins to swell,
NOTE; Do not overtighten or you may crush the
tubing,
Pipe Clamp
Clamp
Screw
Saddle-Type
__/,4
Shutoff Valve
Washer
Inlet End
Vertical Cold
Water Pipe
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to, Saddle valves
are illegal and use is not permitted in Massachusetts,
Consult with your licensed plumber,
[_ ROUTE THE TUBING
Route the tubing between the cold water line and the
refrigerator,
Route the tubing through a hole drilled in the wall
or floor (behind the refrigerator or adjacent base
cabinet) as close to the wall as possible,
NOTE: Be sure there is sufficient extra tubing to
allow the refrigerator to move out from the wall after
installation,
i
D CONNECT THE TUBING TO THE VALVE
Place the compression nut and ferrule (sleeve) for
copper tubing onto the end of the tubing and connect
it to the shutoff valve,
Make sure the tubing is fully inserted into the valve,
Tighten the compression nut securely,
For plastic tubing from a GE SmartConnect TM
Refrigerator Tubing kit, insert the molded end
of the tubing into the shutoff valve and tighten
compression nut until it is hand tight, then tighten one
additional turn with a wrench, Overtightening may
cause leaks,
Nut
Saddle-Type _X
Shutoff Valve _ SmartC°nnectTM
Tubing
Packing Nut --
Outlet Valve -- Ferrule (sleeve)
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to, Saddle valves
are illegal and use is not permitted in Massachusetts,
Consult with your licensed plumber,
[] FLUSH OUT THE TUBING
Turn the main water supply on and flush out the
tubing until the water is clear,
D CONNECT THE TUBING TO THE
REFRIGERATOR
NOTES:
, Before making the connection to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet,
If your refrigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's water valve, Install it in the water line
near the refrigerator, If using a GE SmartConnect TM
Refrigerator Tubing kit, you will need an additional
tube (WXOSXIO002) to connect the filter, Do not cut
plastic tube to install filter,
12