Streaming; Privacy Masking - Eneo PLS-5308 Full Manual

Streaming

• Camera Channels: Select which cameras to apply the
streaming to.
• Primary, Secondary, Tertiary, Quaternary:
Multistreaming is supported. (priority: Primary >
Secondary > Tertiary > Quaternary). Enable/disable
streaming use. The lower stream settings may change
depending on higher stream settings. The tertiary
stream and the quaternary stream may not be able to
use a resolution and fram rate settings depending on
higher stream settings(refer to the table below).
Primary Secondary
Resolution ips Resolution
720x480 (NTSC) 30 720x480 (NTSC)
720x576 (PAL) 25 720x576 (PAL)
• Compression: Choose the streaming compression
method.
• Resolution: Choose a resolution setting for video
streaming. The current stream resolution cannot be
higher than the higher stream resolution.
• Quality: Choose a quality setting for video streaming.
• Bitrate Control: Choose a bitrate control mode for
H.264 compression.
- VBR (Variable Bitrate): Bitrate varies depending
on motion changes in the video. Less movement
places less load on the network and takes up less
storage space.
• Frame Rate: Choose a frame rate setting for video
streaming. The fame rate of the current stream cannot
be higher than the fame rate of the higher stream if
those stream resolutions are same.
If multiple users are connected to the camera, the
increase in bandwidth use can lower the frame rate.
Tertiary Quaternary
ips Resolution ips Resolution ips
30 640x360 360x240
1
25 (NTSC) (NTSC)

Privacy Masking

Select Privacy Masking to set up a privacy mask over
a specific area. The section on which a privacy mask is
applied will appear as black when monitoring video.
• Camera Channels: Select which cameras to apply the
privacy masking to.
• Privacy Masking Setup: Set up privacy masks. (Up
to 16)
1
(Select)/
-
mask. Click on the button and drag & drop using
the mouse to set up a privacy mask.
- No./Name: Displays a list of active privacy masks.
The numbers indicate privacy mask numbers. Select
the empty space next to a number to assign a name
to the corresponding privacy mask. Click Delete to
remove the selected privacy mask.
Part 2 - Remote Setup
(Unselect): Set or remove a privacy
23