Connecting From Remote Pc - Eneo PLS-5308 Full Manual

Connecting from Remote PC

If you want to connect to the video encoder from
a remote PC, it is required to change the network
connection information of the video encoder by
connecting to the video encoders from a local PC.
1
Find the video encoder to connect. Refer to the
explanation of procedures from 1 to 3 in the To
connect from a local PC section above.
2
Select the video encoder to connect and click the
Setup icon. Select IP Address Setup and set up the
network connection information as follows:
• Type: Select Manual or DHCP depending on the
network connection type. If you select Manual, you
need to acquire the IP address, gateway and subnet
mask from your network administrator or Internet
service provider.
• DNS Server: Enter the IP address of the DNS server. If
you selected DHCP for the network connection type,
selecting From DHCP automatically assigns the IP
address of the DNS server.
• Set up FEN: Enable the option by checking the box.
When you check the box, the Next button at the
bottom changes to Next. Click the Next button and
enable the Use FEN option by checking the box.
Set up the FEN function referring to the FEN Setup
section below.
3
Set up the UPnP function in the NAT (Network
Address Translation) device and the video encoder.
See the NAT device User's Manual for details about
setting in the NAT device. See the UPnP Function
Setup in Video Encoder section below for details
about setting the in the video encoder.
If the NAT device does not support the UPnP function,
you have to set up port forwarding manually. Also,
if more than one video encoder is connected to the
NAT device, the port numbers of each video encoder
should be different. See the NAT device User's Manual
for details about setting port forward in the NAT device.
See the explanation of procedures from 1 to 3 in the
UPnP Function Setup in Video Encoder section
below for details about changing port numbers of the
video encoder.
4
Run a remote program on a remote PC and register
the video encoder on the remote program with the
name registered on the FEN server.
Check that firewall is disabled in the router or NAT
device. If firewall is enabled, you may not connect to
the video encoder. Ask your network administrator for
details or see the NAT device User's Manual.
Part 1 – Introduction
13