USB interface to this USB connector enables the evaluation of codec performance. The PCM2900C/2902C/2906C operates from the 5-V bus power supply of the USB. A 3.3-V IC regulator is mounted on the board to provide power for analog circuitry and optionally for the codec.
Description www.ti.com Block Diagram A block diagram of the PCM2900C/2902C/2906C is shown in Figure 3.3 V CN101 Analog Out CN002 S/PDIF IN OPA2353 S/PDIF OUT DOUT PCM2900C CN001 CN102 PCM2902C 12-MHz XTAL Analog In PCM2906C USB Interface Connector OPA2353 V L/R D+/–...
Page 11
Evaluation Board/Kit Important Notice Texas Instruments (TI) provides the enclosed product(s) under the following conditions: This evaluation board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by TI to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards.
IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice. Customers should obtain the latest relevant information before placing orders and should verify that such information is current and complete.
Need help?
Do you have a question about the PCM2900C and is the answer not in the manual?
Questions and answers