Blc Level Adjustment For The Preset 1 Setting - Sanyo VCC-5972P Instruction Manual

3-2. BLC level adjustment for the PRESET 1
setting
1
Set the BLC switch (9) to ON. The on-screen setting for BLC
will automatically switch to ON. Press the CURSOR (j or l)
button to select the on-screen ON setting (get it flashing),
then press the SET button. The adjustment sub-menu
"ADJUSTMENT FOR BLC" will be displayed.
ON CURSOR
OFF
2
Press the CURSOR (d or c) button until PRESET 1 is selected.
3
Press the CURSOR (l) button to select BLC LEVEL (get it
flashing), then press the SET button. The adjustment
sub-menu "BLC LEVEL" will be displayed.
4
While looking at the image on the monitor, press the
CURSOR (d or c) button until the BLC level is obtained. The
on-screen marker (b) will move and the adjustment value will
flash according to the BLC level setting.
Note:
When an adjustment is made, the PRESET setting will
automatically switch to OFF. To return to the initial value, just
return the PRESET setting to ON, then press the SET button.
5
When finished.
(Refer to step 4 on page 14.)
Note:
The BLC level adjustments should be entered under the PRESET 1
or MANUAL 1 settings. The BLC level adjustments entered under
the PRESET 2 or MANUAL 2 settings will not be effective.
MENU FOR ADJUSTMENT
SET
SYNC
IRIS
BLC
ADJUSTMENT FOR BLC
BLC MODE
BLC LEVEL
INT
AI
ON
PRESET1
Example:
If the backlight
compensation (BLC)
correction is insufficient,
press the CURSOR (d or
c) button to move the
on-screen marker close to
the position indicated above.
18
ADJUSTMENT FOR BLC
BLC MODE PRESET1
ADJUSTMENT FOR BLC
(BLC LEVEL)
o------z------p 15
ADJUSTMENT FOR BLC
(BLC LEVEL)
o------z------p 20
PRESET OFF
END MENU
English