STEP 3: Choose a layer 2 interface from the drop-down box and click Next.
The WAN Service Configuration screen will display as shown below.
NOTE:
The WAN services shown here are those supported by the layer 2
interface you selected in the previous step. If you wish to change your
selection click the Back button and select a different layer 2 interface.
STEP 4: For VLAN Mux Connections only, you must enter Priority & VLAN ID tags.
STEP 5: You will now follow the instructions specific to the WAN service type you
wish to establish. This list should help you locate the correct procedure:
(1) For
PPP over ETHERNET (PPPoE),
(2) For
IP over ETHERNET (IPoE),
(3) For Bridging, go to page 137.
(4) For
PPP over ATM (PPPoA),
(5) For
IP over ATM (IPoA),
The subsections that follow continue the WAN service setup procedure.
go to page 126.
go to page 132.
go to page 139.
go to page 144.
125