Adjustable Stand; Compatible Cartridges - jbc AL-2A User Manual

Adjustable Stand

Adjust the tool holder angle to suit your work position.
Changing cartridge
For a safe cartridge change, unplug the tool or turn the station off before following these guidelines:
1. Loosen the cartridge screw to release it.
Place the new cartridge in the Auto-feed iron.
2. Align the tip of the cartridge with the
solder Guide tube.
Important: It is essential to insert the
cartridge till the end for a good connection.
Use the mark as reference. Tighten the
cartridge screw.
3. You must leave a gap of 8-10 mm
between the tip and the end of the Guide
tube.
4. Loosen the guide screw.
Adjust the Guide tube and tighten
the screw.
12
1
Guide tube
Ref . 0002401 - Ø 0,9 - 1,1 mm
2
Alignment
4
8-10 mm
3

Compatible Cartridges

The AL250-B Auto-feed Iron works with C250 cartridge range. Find the model that best suits your
soldering needs in www.jbctools.com
ø 0,8
ø 0,6
ø 0,4
C250-420 C250-401 C250-402
1,8x0,8
1,2x0,7
C250-404 C250-405
1,2x0,7
2,2x1
4,8x1,5
C250-407 C250-408 C250-411
w w w.jbctools.com
ø 1,7
ø 2,2
ø 1
C250-403 C250-409
4,8x1,5
3,2x1,5
2,2x1
C250-406 C250-412
ø 2,2
2,2 x 1
C250-413 C250-414
Note: All the cartridges shown are actual size.
C250-410
C250-418
ø 3,8
C250-415
13