Table of Contents
Advertisement
Keyboard
Wedge V
Keyboard
Wedge W
Keyboard
Wedge X
Resetting the Standard Product Defaults
If programming settings for your scanner are in an unknown condition,
factory settings can be restored by scanning the "Standard Product
Default Settings" bar code below. A listing of factory default settings is
available in the PRG. Settings can vary, depending upon the interface
type.
How to Scan
When the trigger is pressed, the scanner projects a red, horizontal illumi-
nating beam. This beam will remain on until the trigger is released, a bar
code is read, or until a time-out
NOTE
1. Reference the Product Reference Guide (PRG) for more information about the aiming
beam time-out period.
Quick Reference Guide
Standard Product Default Settings
1
period expires.
If the surface being scanned is highly reflective
(e.g., laminated), it may be necessary to tilt the item
or the scanner slightly (15° to 18°) to prevent
unwanted reflection.
How to Scan
1-7
Hide quick links:
Advertisement
Table of Contents
