Table of Contents
Advertisement
CHAPTER 2: Introduction
DIALING
Configure your modem, fax/modem, or fax machine
for Tone dialing.
SPEAKER PHONES
If the attached telephone has speakerphone
capability, disable speakerphone operation. This
mode deactivates the handset jack used to send
and receive data.
LEVEL SWITCH
Set the Level switch for the telephone you are using
(see Chapter 4).
SPEAKER CONTROL AND VOLUME
The telephone handset is deactivated during dialing.
If you use a modem or fax/modem, you can use the
AT command (ATM1 for speaker off when carrier
present) to enable the modem speaker and the AT
command (ATL3 for high volume) to set its volume.
You can then "listen in" on dialed calls to monitor
their status. Refer to your modem manual for
information.
11
Advertisement
Table of Contents
