Component Identifi Cation, Single Axle - Landa MP-373534 Operator's Manual

COMPONENT IDENTIFICATION — SINGLE AXLE MODELS
Spray Gun
Starter
Grip
High Pressure
Hose
Pump — Develops high pressure.
Starter Grip— Used for starting the engine man u al ly.
Spray Gun — Controls the application of water and
de ter gent onto cleaning surface with trigger device.
In cludes safe ty latch.
Detergent Injector — Allows you to siphon and mix
detergents (not shown).
4
Wand
High Pressure
Discharge
8.913-996.0 • 8.914-452.0 • 9.800-084.0 • 8.919-013.0 • Rev. 10/11
Water Inlet
Wand — Must be connected to the spray gun.
High Pressure Hose — Connect one end to water
pump dis charge nipple and the other end to spray
gun.
Note: If trigger on spray gun is released for more
than 2 minutes, water will leak from valve. Warm
water will dis charge from pump protector onto fl oor.
This sys tem pre vents internal pump dam age.
Nozzle
Pump