Makita 9564CVL Instruction Manual page 9

1
1. Lock nut
2. Depressed center grinding wheel/
Multi-disc
3. Inner flange
4. Spindle
1
2
1. Lock nut wrench
2. Shaft lock
1
2
3
1. Abrasive disc
2. Pad
3. Spindle
To remove wheel guard, follow the installation procedure in
reverse.
Installing or removing depressed center grinding
002982
wheel/Multi-disc (optional accessory)
2
3
WARNING:
• Always use supplied guard when depressed center
4
grinding wheel/Multi-disc is on tool. Wheel can shatter
during use and guard helps to reduce chances of
personal injury.
Mount the inner flange onto the spindle. Fit the wheel/disc on
the inner flange and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that the
001084
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing abrasive disc
001115
Remove all dirt or foreign matter from the pad.
Screw the pad onto the spindle with pressing the shaft lock.
Attach the disc to the pad so carefully that the edges of disc
and pad overlap each other without protruding.
To removing the abrasive disc, pull off its edge from the pad.
001157
9