Operation; Eco-Shredding - Royal Sovereign RDS-818C7 Owner's Manual

Cross cut eco-shredder
Table of Contents

Advertisement

Available languages

Available languages

OPERATION

1. Prepare paper or card to be shredded by removing labels,or any other foreign matter.
2. Shred capacity per pass
Paper: 18 Sheets Maximum, Credit Card: 1 Pc. Maximum, CD's: 1 Pc. Maximum
3. Press the swith to REV/FWD position for your desired setting:
REV: Reverses shredding direction and backs item out of the shredder in the event of a jam.
FWD: Forward shredding direction and clear jammed paper in the shredder.
NOTE : ALWAYS UNPLUG THE SHREDDER BEFORE ATTEMPTING TO REMOVE AN ITEM MANUALLY
4. Insert item to be shredded into the appropriate feed opening.
5. The solid basket is for convenient disposal of content.

ECO-SHREDDING

1. When no paper in the throat, the shredder will be always cut off, and will not be turned on by pressing any switch on the panel except the
ON/OFF switch. Potential injuries can be prevented.
2. When inserting paper into the slot, the shredder will be turned on automatically, no need to press the ON/OFF switch at the back of the
shredder again.
3. Plug into a power outlet, press the power switch , the green power light (
is finished, the shredder will be turned off automatically, power consumption is almost zero.
4. When paper is jammed, the paper can be cleared automatically or by pressing REV/FWD switch to turn on the shredder to clear the
jammed paper.
IMPORTANT NOTES
1. If the paper is wider than the feed entry and is folded to fit,the paper thickness increases and the recommended capacity may be
exceeded.
2. If the basket is removed or ajar,the shredder will the safety interlock
3. If the basket does not make completecontact with the asfety interlock switch that is built into the basket frame,the machine will not operate
4. If the shredder is overload, it will automatically shut down and the Red LED light(
again. Please set the switch to "REV" to back the paper out of the unit, then clear redundant paper and press switch on "FWD", the
machine can work normally .
5. If the shredder is overheat , it will automatically shut down and the Red LED light( ) will illuminate until it is safe to resume shredding again.
6. The RedLED light(
) will illuminate if the basket is full of paper.
7. Do not shred labels or paper with labels affxed to them. By doing so will void your warranty. Also this will gum the cutting blades and cause
the shredder to malfunction.
), the shredder is standby for 10 seconds, when shredding
) will illuminate until it is safe to resume shredding
5
RDS-818C7

Advertisement

Table of Contents
loading

Table of Contents