Operation - Royal Sovereign AFX-908N Owner's Manual

OPERATION

INDICATOR AND SWITCH INSTRUCTIONS
Power Switch: Plug in power cable and turn on the switch located on the right side of the machine.
Power On Indicator: When the shredder is turned on the Power On Indicator will light up. If the basket is pulled out or not in correctly the power will
automatically be cut off for safety, and the Power On Indicator will blink. If the Control Switch is turned to STOP the Power On Indicator will be blinking. If
there is an overload of paper, the shredder will automatically reverse. When the paper is cleared the Power On Indicator will blink. To resume shredding,
turn the control switch to STOP then back to AUTO.
Motor Overheat/Overload Indicator: If there is an overload of paper the shredder will automatically reverse. The Motor Overheat/ Overload Indicator
will turn on and the Power On Indicator will blink. To resume shredding, turn the control switch to STOP then back to AUTO. If there is a jam that causes
the motor to heat up or if it has been continuously running for more than 10 minutes the motor will cut off and the Motor Overheat/Overload Indicator
will turn on. This is to ensure the motor does not overheat. When the shredder cools down the light will turn off and you can begin shredding again.
REVERSE Setting: Turn the control switch to REVERSE for manual reversing paper from both entries. If the Power On Indicator is
blinking, turn the switch to STOP then back to AUTO.
AUTO Setting: To automatically shred in both entries turn the control switch to AUTO. If the Power On Indicator is blinking, turn the
switch to STOP then back to AUTO.
STOP Setting: Turn the control switch to STOP to manually stop shredding. To resume shredding turn the control switch to AUTO.
USE INSTRUCTIONS
1. Place the shredder on a flat, level surface.
2. Install the Auto Feed Tray(packed inside the pull-out basket). Insert the two tabs on the bottom of the Auto Feed Tray into the two
slits on the Auto Feed Entry. They are located under the top of the Safety Cover.
3. Plug in power cable and turn the power switch on. Turn the control switch to AUTO. The Power On Indicator will light up.
Auto Feed Entry
1. Turn the control switch to AUTO. The Power On Indicator will light up.
2. Neatly arrange paper to be shredded into a stack of up to 75 sheets.
3. Press down on Center knob of Safety Cover and insert the stack into the Auto Feed Entry. Make sure to push the papers all the way
into the entry. The shredder will automatically begin to start shredding a few pieces of paper in the stack at a time when you release
Safety cover.
4. When the stack of paper is completely shredded, the motor will stop running.
Note: Insert non-stapled side of paper first into Auto-Feed entry
Manual Feed Entry
1. Turn the control switch to AUTO. The Power On Indicator will light up.
2. Insert up to 7 sheets of paper into the Manual Feed Entry.
3. When the stack of paper is completely shredded, the motor will stop running
6