Operation; Clearing Paper Jams; Emptying Waste Bin - Royal Sovereign CS-06D Owner's Manual

opeRAtIoN

1. Place the shredder on a desk, tabletop, floor or other flat surface.
2. Plug the power cord into an electrical outlet.
3. Slide the switch to AUTO selection
• When slide the switch is set to AUTO selection, the device is ready to be used.
4. Insert paper.
5. Slide the switch to OFF after use.
• The shredder may emit some heat when in use. This is normal.
• Note: Do not inset hard objects like card stock, CD/DVD's into the shredder.
CAUtIoN
1. If the shredder runs continuously for long time period, the motor may overheat or shut off automatically. Should this happen, please allow
the motor time to cool down before shredding again.
2. Do not insert staples, card board, clothes etc as it may damage to the device.
3. Unplug the unit when cleaning and emptying the waste bin or when not use for a long time.
Helpful User tips
Clearing a paper jam
Paper jams may occur due to paper being inserted incorrectly, or the sheet capacity has been exceeded. Should this happen the switch to the REVERSE (<<) position,
and remove the excess paper from the top and pull it out. TO PREVENT ANY INJURIES, DO NOT PLACE YOUR HANDS NEAR THE FEED OPENING. Once the paper is
cleared, normal shredding operation can resume. If the shredder jams while in reverse, press the switch to the AUTO position and let shredder run to clear the jammed
paper. If jam does not clear, slide the switch back and forth between the REV and AUTO until the jam is cleared. If the jam cannot be cleared following this procedure,
unplug the unit and carefully remove the jammed paper manually.
overheating
If your shredder overheats, the unit will automatically shut off and all functions will cease in order to protect the motor. Turn off and unplug the shredder from the outlet.
Allow enough time for the motor to cool down. The shredder will not resume normal function until the temperature of the motor cools down to a safe temperature. Once
cool, plug the shredder back into the outlet, turn the unit back on and resume normal operation. Make sure to empty waste basket to avoid overloading the basket and
damaging the cutting mechanism.
Bin Full Function
Some shredders are equipped with a mechanical or optical Bin Full sensor.
When the basket becomes full, the shredder will cease operation. Empty basket to resume operation.
emptying Basket
Always turn the shredder off and unplug the power cord from the AC outlet before cleaning it, moving it, or emptying the wastebasket. Always keep wastebasket emptied
so that the shredder's output is not impeded. Never let the wastebasket get full. This will lead to shredded material being pulled back up into the shredder and cause
jams.
6