Operation - Royal Sovereign AFS-800N Owner's Manual

OPERATION

1. Place the shredder on a flat, level surface.
2. Plug in power cable and turn the switch located on the right side of the machine on. The Power light on the control panel will light up.
3. Insert sheets into the Manual Feed Entry or the Auto Stack Feed Entry. Insert CD's, DVD's, or credit cards into the CD Entry. 7 sheets can be inserted
into the Manual Feed Entry. 100 Sheets can be placed in the Auto Feed Entry(80 Sheets AFS-800BKN) When the Basket Full Indicator turns on, empty
the basket.
If the Motor Overload/Overheat Indicator turns on, let the shredder rest for up to 30 minutes. The indicator will turn off when the shredder has cooled
down. If the shredder door has been opened and closed, you must press the RESET/STOP button then press the FWD button to being shredding again.
In the case of a paper jam, the shredder will automatically reverse for 5 seconds. If the jam does not clear on it's own, remove the jammed papers.
When using the Manual Feed Entry, gently pull the jammed papers out. When using the Auto Stack Feed Entry, lift the Safety Cover and remove the
jammed paper. Then make sure to close the Safety Cover. After the jammed paper is removed press the RESET/STOP button. Then hold down the
FWD button until the shredded pieces of the jammed papers fall into the basket. You can then insert more paper to begin shredding.
NOTE : Above spec is most accurate under 77 °F (25°C) standard.
Automatic Jam Removal System with Display
GREEN LED
When paper is inserted in auto-feed entry, GREEN LED will turn on while shredding.
RED LED
When you insert papers over maximum capacity, RED LED will turn on. Then, motor will go on reverse rotation, taking papers out of paper entry. In this
case, papers should be pulled out by hand, before re -inserting paper under maximum capacity.
BLUE LED
When curled/crumpled paper is inserted it may result in a JAM problem.
If the Auto Reverse function does not remove the paper, the Automatic Jam Removal System will start automatically. During this function, BLUE LED light
will turn on. Shredder will automatically run forward/reverse action for approximately 2~3 minutes until jam is cleared. Do not override control switch
until process is completed.
*If the jammed paper is not fully removed from the Automatic Jam Removal System press and hold the [FWD] button and manually run forward/reverse
motion to remove the jam.
Normal Shredding
Green LED ON
Automatic Jam Removal System in process
(If paper is not sticking out of paper entry it cannot be pulled out by hand)
Blue LED ON
Auto Reverse process
(If paper is sticking out of paper entry it can be pulled out by hand)
Red LED ON
6