Features; Operation - Royal Sovereign RDS-812C5 Owner's Manual

FeatuReS

Paper Feed Capacity
The Paper Feed entry allows users to quickly shred up to 12 sheets at a time. Also shreds small paper clips and staples. The Cd entry allows
users to shred Cd's, dVd's and credit cards, 1 at a time.
On/auto Controls
The shredder automatically starts shredding paper upon insertion and will automatically stop when finished.
Safety Features
As a safety precaution, if the cutting head is taken off the basket or placed incorrectly the power will automatically go off for your safety.

OPeRatION

1. Place the shredder on a flat, level surface.
2. Insert power plug into the electrical outlet and set the slide switch to "AUTO" position.
INDICatOR aND SWItCH INStRuCtIONS
ON/autO position
The machine is ready for operation, shredding starts automatically when paper is inserted in the paper entry.
OFF position
The machine is turned off.
ReV position
When paper jam occurs turn the shredder in reV mode to pull out the jammed paper.
Shredding
Insert up to a maximum of 12 sheets into the paper feed entry. The shredder automatically starts Shredding.
Overload/ Paper jam
When jam caused by inserting too much paper, or you want to withdraw the paper immediately during normal shredding, set the slide switch to "reV".
The machine does the reverse rotation and return the paper that has not been shredded. Slide the switch to "OFF".
Overheat Protection
This shredder will automatically shut itself off after shredding 5 continuous minutes. The machine should be cooled down to room ambient temperature
before resuming operation. (about 50 minutes)
NOte : Please read the instructions carefully before operating the machine. Incorrect operation will cause hazards to users. The mark
"o" printed on the machine indicates the machine is off when the slide switch is in this position.
Shredding CD's, DVD's or Credit Cards
Set the slide switch to "On/Auto" position. The machine is ready for cutting Cd's, dVd's and credit cards. Insert Cd's or credit cards into the entry
vertically. When finish cutting then set the slide switch to "Off" position.
6