RCF SUB 702-AS II Owner's Manual page 7

Stereo female XLR inputs (bal/unbal).
1
Limiter led: the amplifier has a built in limiter circuit to prevent amplifier
2
clipping or transducers overdriving. When the soft clipping circuit is active
the LED blinks orange. It is okay if the limit LED blinks occasionally.
If the LED blinks frequently or lights continuously, turn down the signal level.
Signal led: the signal indicator lights green if there is signal present on
3
the main XLR input.
Power led: this green led is ON when the speaker is connected to the
4
main power supply and the ON/OFF is in ON position.
5
Male XLR signal/xover output: the output XLR connector provides a loop
trough for speakers daisy chaining (or provides a crossover output when the
crossover switch is pushed).
6 Volume control: adjusts the amplifier volume.
Link/xover out switch: the output link is flat when the switch is OFF (the
7
output signal is the same as the input signal), or is high passed when the
switch is ON (to connect a satellite speaker).
Xover switch: this switch sets the crossover frequency of the OUTPUT
8
SIGNAL at 80 Hz or 120 Hz.
Phase switch: this switch reverses the phase of the output signal.
9
IEC AC sockets: the IEC AC socket provides IN-OUT connections for the
10
power cord to the socket and additional power link.
Power main switch: the power switch turns the AC power ON and OFF.
11
REAR
PANEL
2
3
4
6
7
8
9
10
1
5
11
7