Programming Overview - Essex Electronics SKE-34B Installation And Instruction Manual

3. Third Door - Users can be assigned to open a 3rd door.
4. Internal Alarm System - Detect Break-in, Door-ajar & Tamper.
5. Doorbell - Press # at the Keypad to trigger a 1 second output for
a doorbell (not included).

Programming Overview

There are two programming commands used with the SKE 12-Pad
Self-Contained Keyless Entry® System.
*3 is the Programming System Setup (page 12).This programming
command allows the programming of the Master Code, setting the
main relay opening time, allows latching (toggling) of the main relay,
etc.
*1 is the Programming Command for programming user codes
(page 18). When programming the user codes, you have the ability
to assign users authorizations. You can authorize a user to latch (if
the system was set up to latch in the *3 programming sequence),
you can allow a user to program or delete codes or activate one of
the other outputs, etc.
The SKE-12 Pad is configured at the factory. Under normal
installation, there is no need to Configure or Reset the keypad
unless the Beeper needs to be quieter or the Illumination needs to
be activated on the SKE-26 only.
The Default Master Code is: 1 2 3
The Relay On Time is: 5 sec
Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com
11