Adjusting The Movable Toe Kick - Blomberg DWT 14210NBL00 Installation Manual

A
B
C
o
B
s
A
t
C

7.3 ADJUSTING THE MOVABLE TOE KICK

Now that you have successfully installed the dishwasher,
you need to attach the toe kick to the dishwasher. The two
piece toe kick can be adjusted to the height and depth
needed for your kitchen. Be sure to use the slotted toe kick
in the front and the other behind it. They slide into each
other.
1. Insert the movable toe kick brackets into the channel
( A).
2. Make sure that the plastic tab to the left of the “L” opening
on the dishwasher has not closed the channel you will
push the bracket through.
Ý Notice :
Be sure to notice there is a left and a right bracket.
Adjust the toe kick brackets forward or backwards so that
they will align with the kitchen toe kick (B).
Lock the toe kick brackets as shown with the plastic tab in
the figure C by pushing the plastic tab on the dishwasher
into the teeth of the bracket (C).
3. Now attach the toe kick to the bracket with the two
(Ø 1 / " x 5 / ” - Ø 3.5 mm x 14 mm) screws and the caps
8 8
provided as follows.
If the enclosure height is below 34
“o” labelled toe kick (toe kick without slots). Installation
should be done following the steps illustrated in the Figures
A, B and C respectively.
1. Bend tabs on toe kick (o) inwards (A).
2. Secure toe kick to brackets with screws (t) as shown in
the supply bags (B).
3. Attach caps (s) as shown in the supply bags (C).
16
1 / ” (870 mm) use only
14