Adjusting Height; Installing The Foot Supports; Installing The Side Trim Strips - Blomberg DWT 14210NBL00 Installation Manual

Figure A
T20
Figure B

6.3. ADJUSTING HEIGHT

Insert the short leg supports into the legs of the dishwasher.
1 /
1 ”
8
(50mm)
1 /
1 ”
8
(50mm)
Adjust the front foot level with the adjusting wrench to balance
and raise the dishwasher to the enclosure height.
Adjust the rear foot level with a screwdriver to balance and
raise the dishwasher to the enclosure height.
Ý Notice :
= Make sure the dishwasher is plumb and notice dishwasher
can be placed with a small clearance under the counter
top.
Turning the screwdriver in the direction of the black arrows
=
will bring the dishwasher back feet up.
Turning the screwdriver in the direction of the white arrows
=
will take the dishwasher rear feet down.

6.4 INSTALLING THE SIDE TRIM STRIPS

1. Remove the adhesive tape (Figure A).
Place the trim strips on the front edge of the side walls
(Figure B).
7
Supplied (4)