Cleaning Your Machine - Bissell lift-off 94Y2 SERIES User Manual

O
perations
Upright cleaning mode continued

Cleaning your machine

1.
Flush out machine of any remaining residual
solution.
Fill the formula & water tank with hot tap
water and turn on your machine.
Recline handle and press the spray trigger
for about 15 seconds while making forward
and backward passes on carpet. Continue
without pressing the trigger until there is no
more water being suctioned up.
Turn off the machine and wrap the
powercord. Make sure the dirty tank and the
formula & water tank are emptied, rinsed,
and dried before the next use.
Before you replace tank, clean all debris
from red fi lter screen.
2.
Rinse front nozzle of any dirt and debris
Remove portable spot cleaner from the base
of the machine.
Unscrew three screws with Phillips screw
driver and remove nozzle.
Rinse nozzle out at the faucet.
Place back onto the machine by hooking the
tabs into the holes on the bottom sides of the
machine. Secure with screws.
3.
The inside of the end caps can be wiped
out with a clean paper towel, or for a more
thorough clean, the end caps can be taken
off and rinsed clean.
4.
Any loose hair or debris can be pulled from
the brush rolls and thrown away. For a more
thorough clean, follow directions on page
15 for removal of brush rolls.Your machine is
now ready to be stored.
Note: Store cleaner in a protected, dry area. Since this
product uses water, it must not be stored where there
is a danger of freezing. Freezing will damage internal
components and void the warranty.
10
w w w . b i s s e l l . c a
WARNING:
To reduce the risk of fire, electric shock or
injury unplug from outlet before servicing.
2.
Tip:
Let all parts dry completely
and replace onto machine.
8 0 0 . 2 6 3 . 2 5 3 5