Levelling The Unit; Cleaning Before Use; Before Using Your Unit - Sandstrom SWC32B11 Instruction Manual

INSTALLATION
12. Set the door back on to the top hinge. Screw the bottom
hinge into place on the new side. Also screw in the levelling
foot.
13. Check that the door is aligned horizontally and vertically and
that the seals are closed on all sides before finally tightening
the bottom hinge. Re-adjust the levelling feet.

Levelling the Unit

To do this use the two levelling feet at the front of the unit.
If the unit is not level, the door and magnetic seal alignments will
not be covered properly.

Cleaning Before Use

Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water using
a 'wrung-out' sponge or cloth. Wipe completely dry before replacing the shelves and bottle rack. Clean
the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to settle.

Before Using Your Unit

Before placing any wine in the unit, turn it on and wait for 24 hours, to make sure it is working properly
and to allow it time to fall to the correct temperature. Your unit should not be overfilled.
SWC32B11_IB_final110526.indd 7
7
5/26/11 6:26 PM