Installation; Location; Levelling The Unit; Free Space Requirements - Sandstrom SWC6B13E Instruction Manual

Installation

INSTALLATION

Location

When selecting a position for your unit make sure the floor is flat and firm, and that the room
is well ventilated with an average room temperature of between 16°C and 25°C. Placing the
unit in an environment out of this temperature range may affect the cooling performance,
GB
designed storage temperature range 8°C - 18°C may not be reached. Avoid locating your unit
near a heat source, e.g. a cooker, boiler or radiator. Avoid direct sunlight.

Levelling the Unit

To do this adjust the two levelling feet at the front of the unit. If
the unit is not level, the doors and magnetic seal alignments will
not be covered properly.

Free Space Requirements

When installing the unit, ensure that 25 mm
of free space is left at both sides, 50 mm at
the rear of the unit and 25 mm at the top of
the unit. The door can be opened to the right
or the left, depending on which best suits the
location.
Please ensure there is more than twice the
width and depth distance space of the unit
to fully open the door to a maximum angle
of 160°.

Cleaning Before Use

Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm
water using a 'wrung-out' sponge or cloth. Wipe completely dry before replacing the shelves
and bottle rack. Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to settle.

Before Using Your Unit

Before placing any wine in the unit, turn it on and wait for 24 hours, to make sure it is working
properly and to allow it time to fall to the correct temperature. Your unit should not be
overfilled.
12
Max. 160°
Y mm
X mm