Installation; Location; Installing The Door Handle - Sandstrom SWC32B11 Instruction Manual

Installation

INSTALLATION

Location

When selecting a position for your unit make sure the floor is flat and firm, and that the room is well
ventilated with an average room temperature of between 16°C and 32°C. Avoid locating your unit near
a heat source, e.g. a cooker, boiler or radiator. Avoid direct sunlight. If you are placing your unit in an
outbuilding such as a garage or annex ensure that the unit is placed above the damp course, otherwise
condensation will occur on the cabinet. Never place the unit in a wall recess or into fitted cabinets or
furniture.
When installing the unit, ensure that 2 cm of free space is left at both sides and 3 cm at the rear of the
unit. The door can open to the right or the left, depending on what better suits the location. Please
ensure there is adequate space for the door to fully open.
• If you want to have the door swing reversed, we recommend that you contact a qualified
technician. You should only try to reverse the door yourself if you believe that you are qualified
to do so.
• All parts removed must be saved to do the reinstallation of the door. You should rest the unit
on something solid so that it will not slip during the door change process. Do not lay the unit
flat as this may damage the coolant system. Ensure the unit is unplugged and empty.

Installing the Door Handle

1. Remove the 2 decorated caps on the left hand side of the
front of the glass door.
2. Position the door handle over the 2 screw holes.
3. Using a screwdriver and the supplied screws carefully
screw the door handle to the glass door.
Do not over tighten the screws as you may damage
the glass door.
Should you wish to move the unit to another location
and reverse the door, see the "Reversing the Door
Swing" Section.
SWC32B11_IB_final110526.indd 5
Decorated Caps
5
5/26/11 6:26 PM