Listening To Compact Disc - Naxa NPB-426 Instruction Manual

PROTECTING RECORDING
Normally, anything recorded on the tape is automatically erased when new recording is made. It
is possible to protect your recording from accidental erasure by removing the tabs found on the
rear of the cassette.
When the cassette is held with the recorded side upper-most and exposed tape facing the front,
the protective tab will be found on the left rear of the cassette.
All pre-recorded cassette are protected in this way to prevent accidental erasure of the
commercial recording. "Protected" cassette will prevent the record button from being operated.
If at any time you attempt to record and find that this button will not depress, never force the
mechanism or it may be damaged. Check that a cassette has been loaded and that tab has not
been removed. Recording on a cassette from which the tabs have been removed can be done
by covering the tab openings with a piece of adhesive tape.
CARE OF CASSETTE MECHANISM
Gently clean the tape head and pinch wheel/capstan assemblies after every 10 hours of using
the unit.
A range of cassette care products are available.
The erase head and record/play head and the surface of the pinch roller are delicate and must
not be touched with metal objects such as screwdrivers. You may find it easier to clean the
assembly by pressing the PLAY button to bright head and pinch roller into view. Be sure to press
the STOP button after cleaning the mechanism.
Damage to the pinch wheel can occur if the unit is left in PLAY mode with the power switch off.
Under no circumstances should you attempt to lubricate any part of the machine.

LISTENING TO COMPACT DISC

Set FUNCTION SWITCH to "CD/AUX" position. Open the CD door to put in a compact disc.
Close it and start reading. The LED digit always shows the tracks of a disc which are still to be
played. Total number of tracks of the disc is shown in stop mode. If no disc loaded into the
compartment, or the disc is placed upside down or unreadable, the display will show N0.
Playing the Entire Disc
1. Playback will start by pressing CD PLAY/PAUSE button, playback starts with the first track.
The display will show the current track number.
2. To interrupt playback, press CD PLAY/PAUSE button. The signal "PLAY" will be flashing.
3. To resume playback, press CD PLAY/PAUSE button once again.
4. To stop playback, press CD STOP button.
-5-