Tape Recording; Cassette Operation; Auto Stop - Naxa NPB-426 Instruction Manual

CASSETTE OPERATION

PLAYBACK OF CASSETTE
Be sure to tighten any slack tape in the cassette before use, using either a pencil or a ballpoint
pen, simply insert the pen or pencil into the center of spool and rotate to remove slacks.
Depress the STOP/EJECT button to open the cassette door.
Insert the cassette into the compartment with the open end facing upwards and the full reel on
the left hand side, push the cassette well down and close the door, be sure not to touch the tape
surface, Set the Function switch to "TAPE" position and press the cassette play button. To stop
playback, press the STOP/EJECT button once. To release the cassette, press the
STOP/EJECT button again.

AUTO STOP

When the tape reaches the end during playback or recording, the built-in auto stop system will
release the depressed play, record keys. The auto stop system operates while recording from
the built-in radio or CD player, only the cassette function is brought automatically to stop mode
and the radio or CD Player will continue to play.

TAPE RECORDING

1. Install a cassette tape.
2. Set FUNCTION SWITCH to "TAPE" position. After selecting the desired band and tune the
TUNING KNOB to desired broadcast station. Then push down RECORD BUTTON and
PLAY BUTTON simultaneously.
3. After recording the desired broadcast, depress the STOP/EJECT BUTTON lightly, and then
set FUNCTION SWITCH to "TAPE" position in order to listen to the recorded broadcast.
4. If you desire to play recorded broadcast, please follow the instructions explained in playback
section.
ERASURE: When you record over previously recorded tape, the original recording is
automatically erased and replaced by these newly recording materials.
Note: Tape recording is also available for CD playback (set FUNCTION SWITCH to "CD/AUX"
position). See details in CD section.
RECORDING FROM BUILT-IN MIC
1. Set the Function Switch to "TAPE" normal position.
2. Insert a blank cassette tape into the tape deck.
3. Press the RECORD key and the PLAY key simultaneously. You can start the recording
through the built-in MIC.
4. To stop the recording manually, press the Stop/Eject Button.
TYPES OF CASSETTE
Use only good quality cassettes (IEC TYPE 1) for making recordings. May be used to replay
other types of cassette but is unable to make proper recording on these more specialized tapes.
The use of C120 cassettes is NOT recommended in this machine.
-4-