TRENDnet TEW-721BRM User Manual page 29

TRENDnet User's Guide
o Dynamic: Select this option if the IP address can be automatically obtained from
your ISP.
o Static: Select this option if you are required to use a permanent IP address to
connect to the Internet. You must enter the IP address and subnet mask
provided by your ISP.
 Name: Enter your desired connection name.
 NAT: Select whether to enable or disable NAT (Network Address Translation).
Enable this setting to share one WAN IP address with multiple computers on your
network.
 User Name: Enter the user name provided by your ISP.
 User Password: Enter the password provided by your ISP.
 Confirm Password: Re-enter the password.
 Max MRU: Set the maximum rate of cells that you can receive. If provided by your
ISP, enter the rate in the field. Otherwise, leave this field to its default setting.
 DNS Enabled: Select whether to enable or disable DNS (Domain Name System).
 DNS Override Allowed: Select whether to enable or disable DNS override.
 DNS Server 1 / DNS Server 2: If provided by your ISP, enter the DNS server.
Otherwise, leave these fields blank.
 PPPoE Service Name: Enter a PPPoE service name.
 MAC Address: Display the cloned MAC address. Click Clone MAC to clone the MAC
address of your computer.
 PPPoE AC Name: Enter the PPPoE account name provided by your ISP.
 Connection Trigger: Configure how you want your modem router to connect and
terminate the Internet connection. Options are:
o OnDemand: Enables the modem router to cut off the Internet connection after
being idle for a specified period of time. The device automatically re-establishes
the connection when you try to access the Internet again. In the Idle Disconnect
Time field, enter the number of seconds that you want to elapse before your
modem router terminates the Internet connection.
o AlwaysOn: Enables the modem router to be connected to the Internet at all
times. If you are disconnected, the device will automatically re-establish the
connection.
o Manual: Manually configure this setting. Enter the user name and password to
establish the Internet connection.
 Idle Disconnect Time: View the preset idle time before the session is disconnected.
 LCP Interval: Enter the number of seconds that you want to be the interval in
sending LCP (Link Control Protocol) packets.
© Copyright 2014 TRENDnet. All Rights Reserved.
 As system default route: Check this box to set the current setting as the default
route.
 ICMP Reply Enable: Check this box to enable ICMP (Internet Control Message
Protocol) messages to be sent back to the host that sent the message.
 Proxy ARP Enable: Check this box to enable proxy ARP function.
IPoA
If you select IPoA, the screen below is displayed.
 State of Connection: Select whether to enable or disable this connection.
 Name: Enter your desired connection name.
 NAT: Select whether to enable or disable NAT (Network Address Translation).
Enable this setting to share one WAN IP address with multiple computers on your
network.
 External IP Address: Enter the IP address provided by your ISP.
 Subnet Mask: Enter the subnet mask provided by your ISP.
TEW-721BRM
26