Panasonic CF-72 Series Reference Manual page 40

PC Cards
Label-side up
Inserting/Removing PC Cards
Inserting PC Cards
Slide the PC Card in until it snaps into place. Refer to the operation manual
of each card on how to insert the card (insertion is typically label-side up).
CAUTION
When using a PC Card to connect a peripheral device (SCSI, IEEE
1394, etc.):
1 Connect the peripheral device to the card.
2 Turn the device on.
3 Insert the card.
When inserting a card, do not force the card in if difficulty is en-
countered. You may damage the slot, making it impossible to re-
move the card.
Removing PC Cards
CAUTION
Do not remove a PC Card while your computer is in the standby or
hibernation mode.
When two PC Cards are inserted, perform the following procedure
(from Step
Note that the operation of removing the PC Card may not be com-
plete, depending on the status of the PC Card or device connected
to the PC Card, such as when a SCSI card is used to connect an
external hard disk to the computer. In such cases, turn off the power
from the [Start] menu, then remove the card.
Windows 2000
Double-click
Follow the on-screen instructions.
(When the PC Card has been removed after the computer is turned
off, this step is not necessary.)
Windows XP
Double-click
Follow the on-screen instructions.
(When the PC Card has been removed after the computer is turned
off, this step is not necessary.)
Press the button, and then press the button again.
Slide the PC Card out.
to Step ) for each of the two cards.
on the taskbar, select the PC Card, then select [Stop].
on the taskbar, select the PC Card, then select [Stop].
40