Panasonic CF-72 Series Reference Manual page 37

CD Drive
Setting a Disc
Title-side up
Eject Button
Center Holder
Software Preparation (first time only)
Windows 2000
Confirm that [Transfer Mode] is set to [DMA if available] in [Control Panel] - [System] - [Hardware]
- [Device Manager] - [IDE ATA/ATAPI controllers] - [Secondary IDE Channel] - [Advanced Set-
tings] - [Device 0]. Perform this setting if it has not yet been made.
Windows XP
Confirm that [Transfer Mode] is set to [DMA if available] in [Control Panel] - [Performance and
Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] - [Second-
ary IDE Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has not yet been
made.
1
Turn your computer on
2
Press the disc eject button and slowly pull out the tray
3
Place the disc securely on the center holder
4
Close the tray
CAUTION
Do not apply excessive force to the tray in the open position, doing so could
damage the tray.
NOTE
If the vibration of the CD drive is excessive, set the [CD Drive Speed] to
[Low] in the Setup Utility.
For AutoPlay CDs:
• If an AutoPlay CD does not start after the computer resumes from the
standby or hibernation mode, we recommend reinserting the CD again
after a 15-second wait.
• An AutoPlay CD may start during the access of a file.
37