Troubleshooting; Before Calling For Service - LG LRE30453SW Owner's Manual

BEFORE CALLING FOR SERVICE

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this appliance.
Problem
Range is not level.
Cannot move appliance
easily.
Appliance must be
accessible for service.
Oven control beeps and
displays any F code error.
Surface units will not
maintain a rolling boil or
cooking is not fast
enough
Surface units do not work
properly
Surface unit stops
glowing when changed
to a lower setting
Areas of discoloration on
the cooktop
Frequent cycling on and
off of surface units

TROUBLESHOOTING

Possible cause / Solution
Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
Adjust leveling legs at base of range until the oven rack is level.
Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are square
and have sufficient room for range clearance.
Cabinets not square or are built in too tightly. Contact builder or installer to make appliance
accessible.
Electronic control has detected the fault
condition. Press CLEAR/OFF to clear
the display and stop beeping.
Reprogram oven. If fault recurs, record
fault number. Press CLEAR/OFF and
contact a Service agent
Improper cookware being used.
- Use pans which are flat and match the diameter of the surface unit selected.
In some areas, the power (voltage) may be low.
- Cover pan with a lid until desired heat is obtained.
A fuse in your home may be blown or the circuit breaker tripped.
- Replace the fuse or reset the circuit breaker.
Cooktop controls improperly set.
- Check to see the correct control is set for the surface unit you are using.
Food spillovers not cleaned before next use.
- See Cleaning the glass cooktop section.
Hot surface on a model with a light-colored cooktop.
- This is normal. The surface may appear discolored when it is hot. This is temporary and
will disappear as the glass cools.
This is normal.
- The element will cycle on and off to maintain the heat setting.
- 32 -
.
CODE CAUSE
F-1 Shorted keypad
F-2 Door locking system don't operate
F-3 Open oven sensor
F-4 Shorted oven sensor
F-7 No heating
F-9 Oven is too hot
.
.
.