Chevrolet 2011 Volt Owner's Manual page 42

2-6 Keys, Doors and Windows
This procedure will take
approximately 30 minutes to
complete. The vehicle must be
off and all of the transmitters
must be in the vehicle.
1. Insert the vehicle key of the
transmitter into the key lock
cylinder on the outside of the
driver door and turn the key to
the unlock position five times
within 10 seconds.
The Driver Information Center
(DIC) displays REMOTE LEARN
PENDING, PLEASE WAIT.
2. Wait for 10 minutes until the
DIC displays PRESS START
BUTTON TO LEARN and then
press the POWER button on
the center stack.
The DIC display will again show
REMOTE LEARN PENDING,
PLEASE WAIT.
3. Repeat Step 2 two more times.
After the third time, all previously
known transmitters will no longer
work with the vehicle. Remaining
transmitters can be programmed
during the next steps.
The DIC display should
now show READY FOR
REMOTE # 1.
4. Remove the rubber mat in
the instrument panel storage.
Extend the key blade on the new
transmitter and insert the key
blade into the transmitter slot.
I n f o r ma t i o n P r o v i d e d b y :
5. Press and hold the POWER
button for two seconds. When
the transmitter is programmed,
the DIC will show that it is ready
to program the next transmitter.
6. Remove the transmitter from the
transmitter slot and press
the transmitter.
To program additional
transmitters, repeat Steps 4
through 6.
When all additional transmitters
are programmed, press and
hold the POWER button
for 10 seconds to exit
programming mode.
on