Entering Multiboot Express Preferences; Using Hp Pc Hardware Diagnostics (Uefi) (Select Models Only) - HP EliteBook 745 G2 Maintenance And Service Manual

4. In the MultiBoot Express Popup Delay (Sec) field, enter the length of time in seconds that you want the
computer to display the startup location menu before it defaults to the current MultiBoot setting.
(When 0 is selected, the Express Boot startup location menu is not displayed.)
5. To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of the
screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select Main > Save Changes and Exit, and then press enter.
Your changes go into effect when the computer restarts.

Entering MultiBoot Express preferences

When the Express Boot menu is displayed during startup, you have the following choices:
● To specify a boot device from the Express Boot menu, select your preference within the allotted time,
and then press enter.
● To prevent the computer from defaulting to the current MultiBoot setting, press any key before the
allotted time expires. The computer will not start until you select a boot device and press enter.
● To allow the computer to start according to the current MultiBoot settings, wait for the allotted time to
expire.

Using HP PC Hardware Diagnostics (UEFI) (select models only)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine if the computer hardware is functioning properly. The tool runs outside of the
operating system to isolate hardware failures from issues that may be caused by the operating system or
other software components.
To start HP PC Hardware Diagnostics UEFI:
1. Turn on or restart the computer, quickly press esc, and then press f2.
After pressing f2, the BIOS searches three places for the HP PC Hardware Diagnostics (UEFI) tools in the
following order:
a. Connected USB drive
NOTE:
HP PC Hardware Diagnostics (UEFI) to a USB device on page
b. Hard drive
c. BIOS
2. Click the type of diagnostic test you want to run, and then follow the on-screen instructions.
NOTE:
104 Chapter 7 Computer Setup (BIOS), MultiBoot, and System Diagnostics in Windows 8.1
To download the HP PC Hardware Diagnostics (UEFI) tool to a USB drive, see
If you need to stop a diagnostic test while it is running, press esc.
105.
Downloading
ENWW