Canadian/Gate Operator Programming - Jeep Compass 2015 Owner's Manual

184 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
3. Without releasing the button proceed with "Program-
ming A Non-Rolling Code" step 2 and follow all
remaining steps.

Canadian/Gate Operator Programming

For programming transmitters in Canada/United States
that require the transmitter signals to "time-out" after
several seconds of transmission.
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink®
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
1. Cycle the ignition to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)
away from the HomeLink® button you wish to program
while keeping the HomeLink® indicator light in view.
3. Continue to push and hold the HomeLink® button,
while you push and release ("cycle") your hand-held
transmitter every two seconds until HomeLink® has
successfully accepted the frequency signal. The indi-
cator light will flash slowly and then rapidly when
fully trained.
I n f o r ma t i o n P r o v i d e d b y :