Jeep Compass 2015 Owner's Manual page 117

The following are general phone to Uconnect® Phone
pairing instructions:
1. Activate the Bluetooth® on your mobile phone.
2. Push the button to begin.
3. After the "Ready" prompt and the following beep, say
"Device Pairing."
4. When prompted, after the beep, say "Pair a Device"
and follow the audible prompts.
You will be asked to say a four-digit Personal Identifica-
tion Number (PIN), which you will later need to enter
into your mobile phone. You can enter any four-digit
PIN. You will not need to remember this PIN after the
initial pairing process.
For identification purposes, you will be prompted to give
the Uconnect® Phone a name for your mobile phone.
Each mobile phone that is paired should be given a
unique phone name.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 115
You will then be asked to give your mobile phone a
priority level between one and seven, with one being the
highest priority. You can pair up to seven mobile phones
to your Uconnect® Phone. However, at any given time,
only one mobile phone can be in use, connected to your
Uconnect® System. The priority allows the Uconnect®
Phone to know which mobile phone to use if multiple
mobile phones are in the vehicle at the same time. For
example, if priority three and priority five phones are
present in the vehicle, the Uconnect® Phone will use the
priority three mobile phone when you make a call. You
can select to use a lower priority mobile phone at any
time (refer to "Advanced Phone Connectivity" in this
section).
Dial By Saying A Number
• Push the button to begin.
• After the "Ready" prompt and the following beep, say
"Dial."
I n f o r ma t i o n P r o v i d e d b y :
3