Equipment Required For Assembly; Package Illustration - KDS Chase 360 Instruction Manual

When you see the marks as below, please use glue or grease to ensure flying safety.

5.Equipment Required for Assembly

•Brushless electric motor: 6s Lipo - 1900KV
(3mm Bolt holes, 25mm mount width, 4mm * 57.5mm motor shaft)
•Speed controller: minimum 50A
(ESC specs limits should be rated accordingly to the maximum amps handling by the motor)
•Lipo Batteries: 6S 1200-1500 mAh
•Electronic flybarless system
•3 cyclic servos, standard size
•1 tail rotor servo, standard size, high speed required
•360 mm main rotor blades
•58-62mm tail rotor blades
•6 channel or more helicopter transmitter system, 2.4 Ghz frequency preferred
•Receiver 6 channel or more (working with your transmitter specs)

6.Package Illustration

Colorful painting canopy x1
Metal parts of main Rotor Head x1
Metal parts of main frame x1
Metal parts of Tail Unit x1
2mm
"A" Glue width: approx. 2mm
"OIL" Lubrication grease. "A" thread lock, apply a small amount on screws or metal parts
and wipe surplus off. When disassembling, recommend to heat the metal joint about 15
seconds. (NOTE: Keep plastic parts away from heat.)
RADIO TRANSMITTER AND ELECTRONIC EQUIPMENT REQUIRED FOR ASSEMBLY
Tail boom x1
Drive shaft(torque tube) x1
Tail boom brace x2
Tail pitch linkage rod x2
Main blade holder x1
Electronic
Accessories Boxes
Page. 3