Safety Check Before Flying; Prevent Moisture; Proper Operation; Safe Operation - KDS Chase 360 Instruction Manual

PREVENT MOISTURE

R/C models are composed of many precision electrical components. lt is critical to keep the model and associated equipment away from moisture and other contaminants.
The introduction or exposure to water or moisture in any form can cause the model to malfunction resulting in loss of use, or a crash. Do not operate or expose to rain or
moisture.
KEEP AWAY FROM HEAT
R/C models are made up of various forms of plastic. Plastic is very susceptible to damage or deformation due to extreme heat and cold climate. Make sure not to store the
model near any source of heat such as an oven, or heater. lt is best to store the model indoors, in a climate-controlled, room temperature environment.

PROPER OPERATION

Please use the replacement of parts on the manual to ensure the safety of instructors. This product is for R/C model, so do not use for other purpose.

SAFE OPERATION

Operate this unit within your ability. Do not fly under tired condition or improper operation, which may cause danger.

3.Safety Check Before Flying

Before flying, for safety reasons, make sure that no one else is operating a R/C model on the same frequency as yours.
Before flying, please check that the power of your transmitter and your helicopter are sufficient for the flight.
Before turning on the transmitter, please check that the throttle stick is in its lowest position, IDLE UP switch must be on OFF position.
When turning off the model, please follow the power on/off procedure. Power ON: turn on the transmitter first, then turn on
helicopter power. Power OFF: turn off the helicopter power first and then turn off the transmitter. Improper operating procedure
may cause the model to be out of control, so please do make this your habit.
Before operation, check that every movement is smooth and directions are correct. Inspect servos carefully for interferences and broken gears.
Check for missing or loose screws and nuts. See if there is any cracked and/or incomplete assembly of parts.
Check main rotor blades and rotor holders carefully. Broken and premature failures of parts might result in a dangerous situation or crash.
Check all ball links to avoid excess play and replace as needed. Failure to do so will result in poor flight stability.
Check that the battery and power plugs are fastened. Vibrations and violent flight might loosen the plugs and so lead to out of control.
Check for the tension of main drive belt.

4.Tools Required

-Hex drivers : 1.5, 2, 2.5, 3, 4mm
-Nut Drivers : 2, 4, 7mm
-Ball link pliers
-Diagonal cutting pliers
-Scissors
-Metric ruler
-Soldering iron + solder (for motor and ESC wiring)
-Pitch gauge (for set up)
-Swashplate leveller
-Threadlock blue * (medium)
-Threadlock red * (high strength)
-Bearing retainer compound
-Epoxy A+B Glue
-Grease
-Oil
*Colors may vary depending on your area.
Page. 2