2.11.3 General Information - Beyerdynamic Opus 600 Operating Instructions Manual

Opus 600 – ZAS 800 Antenna Splitter
1. Mount the ZAS 800 antenna splitter and the NE 600 receivers into a 19" rack by using the
mounting brackets.
2. Connect the supplied antennae to the antenna sockets A/B
antennae. For mounting the antennae on the front use the optional FB 30 mounting bracket.
3. Connect the NE 600 receivers to the ZAS 800 antenna splitter with the supplied cables.
4. Connect the power supply unit to the DC-connection
the indicated voltage corresponds to the local voltage.)
5. Switch on the ZAS 800 antenna splitter

2.11.3 General information

1. The antenna sockets
the rack housing.
2. For the connection of remote antennae use usual 50 Ω coaxial cables. The longer the cable, the
higher the RF signal loss. Therefore, the cable length should not exceed 6 m.
The larger the diameter of cable, the lower the signal loss. If you need cables longer than 6 m you
should therefore use cables with a larger diameter to reduce the loss of signal.
3. Use 50 Ω coaxial cables to connect the NE 600 receivers to the ZAS 800 antenna splitter. The
distance between these devices should be as short as possible. We recommend using the supplied
cables.
4. Supplied accessories:
8 x RG 58 AU cables, 40 cm (TNC)
1 pair FB 30 rack mount brackets (incl. front mounting option)
1 x power supply unit
.
have a voltage of 8 V DC. To avoid a short circuit the sockets must not touch
. You can also use optional remote
and to AC power. (Caution: Make sure that
45