Connect To A Network - Aztech WL593USB User Manual

Connect to a Network

In Connecting to a Network, you can do any of the three options:
a. Connecting to an Access Point via the WPS button
b. Connecting to an Access Point using the WL593USB Utility
c. Connecting to an Access Point using Wireless Zero Configuration
A. Connecting to an Access Point via the WPS button
1. Use the WPS button to immediately connect to your Access Point.
2. Press the WPS of your Access Point for 5 seconds.
3. Press the WPS button of the Aztech WL593USB device for 5 seconds.
4. The WL593USB LED will start to blink during pairing. To confirm the connection, see
status of the Wireless Connection if connected.
Note: WL593USB WPS button should be pressed for 5 seconds and within 2mins after pressing
the WPS button of your Access Point to ensure a successful connection between your
devices.
B. Connecting to an Access Point using Realtek USB Wireless LAN
Utility
1. Install the Resource CD on the computer where you would be connecting the Aztech
WL593USB device.
2. Double click
by clicking Start > All Programs REALTEK USB Wireless LAN Utility.
to launch the Aztech WL593USB utility or you can also run the utility
User Manual
Page 11 of 31