User Manual
Connect to a Network
In Connecting to a Network, you can do any of the three options:
a. Connecting to an Access Point via the WPS button
b. Connecting to an Access Point using the WL592USB Utility
c. Connecting to an Access Point using Wireless Zero Configuration
A. Connecting to an Access Point via the WPS button
1. Use the WPS button to immediately connect to your Access Point.
2. Press the WPS of your Access Point for 5 seconds.
3. Press the WPS button of the Aztech WL592USB device for 5 seconds.
4. The WL592USB LED will start to blink during pairing. To confirm the connection, the
Wireless Network Connection on your computer will change
Note: WL592USB WPS button should be pressed for 5 seconds within 2mins after pressing the
WPS button of your Access Point to ensure a successful connection.
B. Connecting to an Access Point using the WL592USB Utility
1. Install the Resource CD on the computer where you would be connecting the Aztech
WL592USB device.
2. Launch the Aztech WL592USB utility and connect to your existing Access Point.
3. Wireless Utility will display Access Point with 2.4GHz and 5GHz band.
Page 14 of 38
to
.