Table of Contents
Advertisement
Step 1
Unpacking
Check that you have the following items:
• Remote commander
WL-AVP800
• Two R6 (size AA) batteries
Step 2
Inserting batteries into the remote commander
1 Turn the commander
over, and remove the
cover.
Notes
• With normal use, the batteries should last for approximately six months.
• Use two size R6 (AA) batteries.
• If you use the batteries incorrectly, they may leak or explode. See notes
below for correct usage.
– Insert the batteries with correct polarity as shown above.
– Do not use a new battery together with an old one.
– Do not use different types of batteries together.
– Do not recharge the batteries.
– If you are not going to use the remote commander for an extended period
of time, remove the batteries to avoid possible damage from battery
leakage.
– If battery leakage should occur, wipe off the leakage from the battery
compartment, then insert new batteries.
• Do not let direct sunlight or powerful artificial light fall directly on the
remote sensor on the front panel of the player. Such light interferes with
the signals from the remote commander, causing the remote commander to
fail to operate correctly.
• Audio/Video cable
• AC plug adaptor (supplied with models other
than Hong Kong and China models)
2 Check the polarities and
position two R6 (size
AA) batteries correctly.
3 Close the cover.
Getting Started
5
-EN
AVP-800.3-800-709-31 [ En, C ]
Advertisement
Table of Contents
